RepTab – Open Source Torch Table in MAKE Zine

RepTab, our open source torch table – was featured in the January edition of MAKE Zine. Read the full article online at MAKE. You can follow the history of this development in former blog posts. Read more about RepLab – the Open Source Fab Lab – of which RepTab is a part.

Categories: Digital Fabrication, Flexible Fabrication, Open Source Fab Lab, Personal Fabrication, RepLab, RepTab, Torch Table

[4] Comments

4 Responses to “ RepTab – Open Source Torch Table in MAKE Zine ”

Comments:

Leave a Reply

Trackbacks & Pingbacks:

Pingback from P2P Foundation » Blog Archive » Open Source Induction Furnace, Torch Table, Multimachine
January 26th, 2010 at 4:39 pm

[...] Source Ecology’s wiki describing the Open Source Induction Furnace project, a blog post about RepTab, a self-replicating, Open Source Torch Table, and also some initial steps to the Open Source [...]

Pingback from Fabrication Ergonomics | Open Source Ecology
February 10th, 2010 at 2:18 am

[...] we had RepTab, the open source torch table up and running already – we could cut the 1/8″ sheet in about 5 minutes at the rated [...]

Pingback from Open Source Drill Press: Prototype Debut | Open Source Ecology
July 7th, 2010 at 3:12 pm

[...] holes in 1″ thick metal, and shearing up to 12″ wide slabs of 1″ thick steel; (3) torch table for cutting meta via computer control; and (4) heavy duty lathe for making motor couplers. The [...]

Open Source Ecology